After putting the plastic shells back on, I realize next time I should make the wires on the capacitor slightly longer, by perhaps another 1/8 to 1/4 inch. This took some extra force to get the shell on, because the solder and capacitor wire made the connector a little thicker. Push the connectors back into the shells using a pin. Use a very small amount of solder, to keep it from wicking into the pin receptacle, which would prevent it from sliding onto the ICSP header on the Arduino.Ĭut the wire off of the extra Dupont wire connector we are putting the in the RST position of the completed connector end. Use locking forceps to clamp wires in place and to act as a heatsink to protect the wire insulation, and solder a capacitor to the connectors.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |